Started my morning with the following error.
the procedure entry point..
?setGhoseSize@BaseDocModelContext_c@@UEAAXJ@Z could not be
located in the dynamic link library sldappu.dll..
Any one have an idea?
James, I was going to say just that. Whenever I come across a weird message, I don't jump to conclusions and start blaming the software engineers - I start again and see what happens after that.
well I must have gremlins this morning. did the morning chores and just gave up and rebooted.
now SolidWorks starts up just like always.
about the only software engineers I blame are the ones at M.S.
maybe the daylight savings time switch that happened over the weekend.
Retrieving data ...