How can I cut the cross into this bowl so that it is round shaped? (Kind of curving with the bowl instead of flat) the deepest spot being 2" deep.
How can I cut the cross into this bowl so that it is round shaped? (Kind of curving with the bowl instead of flat) the deepest spot being 2" deep.
Offset a surface from the bottom face and cut to that surface. Or, cut to an offset of the bottom surface.
Steve C
Thanks!!!! I got it to work!
Cory, how about you click the "Correct Answer" button so this can be closed out and we can all move on.
thanks...
Cori** Ouch sorry I'm new at this..
HAPPY FRIDAY!!
Cori Thiede wrote:
Cori** Ouch sorry I'm new at this..
Don't worry about it. We were all new here once. Welcome to the forum, by the way. And here's a good place to go to help you get the most from the forum if you'd like to take a look at it: Forum Posting .
Cut, direction = offset from surface
1 less feature than Steve's way. Either one works though.
Depending on the complexity, I tend to default towards making a separate surface and give it a name.
Steve C
Offset a surface from the bottom face and cut to that surface. Or, cut to an offset of the bottom surface.
Steve C