I am having issues exporting dxf from sw model into various cad programs. Issue is my Y axis dimension shows correctly but my X axis is off. The attached file x axis is 15" per sw model but reads 14.5" as a dxf.
Thank you for any assist in advance
Well, I just downloaded the model and opened it.
The very first thing that I noticed was that your units were being rounded to the nearest 1/2" fraction, which in this case, will round it up to 15".
After changing it to 4 decimal places and re-measuring the model, I am getting 14.75" for x-axis length.
Not sure why you are getting the 14.5" dimension once it is converted to DXF though.
I converted it to DXF and then brought it back into SW and I am still getting 14.75" on x-axis.
Although, if you wanted it to show in the proper fraction, then you could change the fraction to 64
This will round it to the nearest 1/64" fraction
Thank you. So obviouse once pointed out....
No problem! Honestly, this has happened to me before as well.
Retrieving data ...