How do I control the angle of the corner treatments for weldments? I have two weldments that meet at a 105 deg angle. I would like to control the angle to 60 & 45.
Welcome to the forum. I don't believe you can do that with a weldment function. You can model each piece separately and miter them with separate extruded cuts.
This may not be the most elegant method, but here goes.
1. Create your two structural members at the angle desired, without applying corner treatment.
2. Chamfer the end of one structural member as needed.
3. use the trim command to finish.
Thank you for these answers Mr. Schroeder & Mr. Patterson
Retrieving data ...