AnsweredAssumed Answered

Edge gap too large when converting to sheetmetal.

Question asked by Akram Mousa on Mar 10, 2016
Latest reply on Mar 10, 2016 by J. Mather

Hi All,

I'm drawing a sheetmetal bumper using surfaces then converting it to sheetmetal. However, I'm getting rathe large gaps about 1.6mm where I specified 0.1mm.

I've tried with another software had a much better result. I wonder if I need to take some extra care with SW.

 

 

 

fr_bumper_v3_001.jpg

Outcomes