I have run a motion simulation and obtained results as attached.
Is there any way I can change the stress range values on the plot? I know I can change the values in Simulation but cant find how to do it in Motion.
Im motion simulation, the obtained plots and results are mostly like a graph. However, if you are looking to change the graph scale, you can do it by right clicking on an azix and go to axis properties and change one of the axises scale (please see images below).
Please let me know if it answers your question.
Hi Siavash, the results I am looking at are the stress plot, not the plotted curves (see my image)
Could you please elaborate more on your need! This is what you mentioned that you are looking for: "I know I can change the values in Simulation but cant find how to do it in Motion".
Are you looking to get stress results out of Motion Simulation?
Yes, have a look at the image I attached. I am working in Motion to get stress results as shown.
Just curious, if your reported stress is almost 5x your YS why would you be interested in these results? Seems the study is already way outside the limitations of linear analysis.
I'm using this model to learn how to use the software. its not an actual design.
Could be a case of singularity, as its appearing near the hole edge. Could be worth investigating
I set up the constraint with load bearing face on one side only (for speed of setup) that's why there is a stress concentration on that side
Retrieving data ...