I'm running a design study on a static simulation for one of our inspection fixtures. I'm looking for the thinnest (lightest!) fixture that we can bolt our parts to that will show an acceptable amount of deformation.
My static simulation runs by itself, and the results look good. The problem happens when I run the design study that references back to the simulation. It gets through the first iteration, and then flashes the following
Thinking that it was some sort of missing file issue, I repaired my copy of Solidworks. That didn't seem to fix the issue. I am using the new for 2016 "Intel Direct Sparse" solver, and I think I'll try it with the regular direct sparse to see if that solves the issue.
I'm not sure where else to go from here and any help you can provide would be greatly appreciated. Thanks for your time.