I am using a Dell Precision M6700 Laptop - NVIDIA Quadro K5000M
SolidWorks 2016 SP2
Windows 7 Pro
Notice the images below - why is there ghosting?
You can always try a quick registry reset to see if that gets rid of your ghosting. Remember you can always go back to your original setup, this is just to see if your SOLIDWORKS reg is corrupt.
Steps to potentially fix your issue:
Hope this helps,
have you checked to ensure you're machine has the approved driver for the card / SW2016 combo?
i ran RX and found two "Approved" drivers. I tried both and the same results.
Do you happen to use/have any 'infinite length" lines in any of your sketches?
No I do not use Infinite Length line
Does it go away if/when you 'roll back' in the feature tree?
Rolling back does not change the ghosting.
It seems as if ALL my settings or set to transparent - at a very low percentage.
That fixed the problem.
My pleasure Henry!
Retrieving data ...