Outside Diameter is Ø100mm and the Width of CAM is 30mm.
what is the formula?Ways?techniques to make a Barrel CAM?
Barrel Cam? How to create profile?
I've used the profile method. Though, the part was never made, we went a different route.
the way I do it is make a profile that cuts deeper than you want and further than you want at each of the transition points, then do a loft with tangency depending your transition you need (harmonic, etc). then follow up with a full extrude to get the depth. I find that doing a sweep gives in accuracy's and is hard to dimension on a print.
how do I attach a file?
Use the "Use advanced editor" link in top right corner of reply/message, then in bottom right is an attach link.
Attached. this is the just of it, you would need to modify certain things to get what your looking for.
Retrieving data ...