5 Replies Latest reply on Feb 26, 2016 6:14 PM by Paul Salvador

    Cannot get a Draft Feature to work on an angle.

    Gabriel Sellers

      Hi all, I am a university student and even my professor couldn't help me with this question.

      I have been asked to make a draft to acquire this shape. However this draft does not come out properly. I can make a regular draft on a flat plane but not here. Below is what I need it to look like and what happens when I try myself.

      I was instructed to make a two inch extrusion on top of the angled piece and select the top face and then the cylinder.

       

           This is before applying the draft.

           This is the intermediate step I was told to do.

           This is what I choose for the draft. No matter what Draft Face or Direction of Pull I choose gets this the correct way.

           This is the horrifying result. (Angle chosen was 30 degrees just like the angled piece below it.

       

      Thanks for your time!

       

      I'll attach the solidworks file as well without my changes done in the above steps.