AnsweredAssumed Answered

what is best practice for making hoppers with flanges top and bottom ?

Question asked by Curtis Penner on Feb 26, 2016
Latest reply on Feb 26, 2016 by Randal Swearingen

We design lots of hoppers with rectangle flanges top and bottom. sometimes they are parallel, sometimes they are not, and in all dif directions, sometimes square to round, I have attached a pdf file sample of a hopper. The flanges are sub assemblies not much of a problem there, but comments would be interesting, but my main question is the sheet metal part. I would like to have the joint on a corner so this part would only require 1 bend per part, and a weld in each corner of asm. I am fairly new to solidworks and other than the frustrating learning curve I am loving it. What is the best way to go about this ?

Attachments

Outcomes