This is intellectual property and I therefore cannot upload the model. This is an illustration of what I have:
In motion analysis I need to simulate the stress on the assembly in red. What I have done:
Selected the cylinder as a linear motor with a Oscillating distance of 800mm (Stroke)
It does animate correctly but when I go to the “Simulation Setup” it does not allow me to select the assembly in red in order to simulate stresses.
I released what the problem was. I should just carefully read the messages that pop up. In the simulation setup it only allows you to select parts and not assemblies, so I should simply save the ASSY as a part and replace it with the part file.
Retrieving data ...