I need to create the edge flange as shown in the picture .I create the miter flange , but it gives me error
The file is here
I think this is what it is supposed to be Sam.. Check out the flange sketch and flange position of the attached.
This is an exam question.
Are you learning the tasks? Or just memorizing the answers?
Did you notice the first word in your image's header?
Kevin,, I think this is a legitimate sample test I found on the My SW support site a couple of years back. The screenshot is taken from the pdf. Hmm?.. Unless this guy has gone rogue.
It was one of my exam questions and it's not part of the SW sample exam.
I just find it disconcerting to see direct exam questions being posted.
I've also seen the LP tank problem posted here as well.
Whether Mr. Lee knew this is an exam question, I do not know, so I must apologize to you, Mr. Lee, for assuming your "guilt".
This was a part of the questions in my exam for cwsp sheetmetal
One thing I didn't consider in my original rant is that, like the CSWE exam, the sheet metal exam may have been updated since we took it.
So maybe now, that part isn't in the exam and is free game for practice (w/o cheating).
Retrieving data ...