This content has been marked as final. Show 4 replies
Hallo all! Good to be here!
I am in need of a macro that will cycle through all open drawings in solidworks and save them as individual pdfs to a target location (nothing special like revisions needed in the file name).
I've found one that will do the cycle-through and save operation, however it automatically saves to the same location as the drawing. Is there a way to modify the attached macro so that it prompts you to select a target destination, then runs through the open drawing files saving each of them to it?
I've searched far and wide for a macro that will do this, but alas to no avail. Normally I'd use the task scheduler but in this case I can't, hence the desire for an awesome macro Can anyone help?