AnsweredAssumed Answered

Pipe Configuration

Question asked by Dave Smith on Jan 30, 2016
Latest reply on Feb 1, 2016 by Dave Smith

I made a custom pipe configuration in the Design Table at the interval of 1" and it works fine. (From 1" length to 100" Length). Now I am asked to make same pipe configuration at the interval of 0.25" and it should show up in the "Length Selection Box" in following format.

 

1"

     1.25"

     1.50"

     1.75"

2"

     2.25" 

and so on. (to pick up the correct length easily)

 

It will be unproductive to type these numbers in excel table, even if I type it they will show up in one column,  There must be a way to do it by drag the (Auto Fill) cell handle which I am unable to find. Any help is appreciated.

 

Thanks,

Outcomes