I'm having a problem that started only recently with saving a part file as a parasolid. When I attempt to save as a parasolid, I get an error message saying 'The file could not be saved. Please verify that the name of the file was valid and that there was sufficient disk space to save the file.' I have tried simple names that would for sure work, and I have checked my disk space and I have plenty. It seems to only be a problem saving as a parasolid, and it isn't the CAD itself because when attempting to save as a parasolid on someone elses computer using the same geometry, it worked perfectly fine. Again, this problem only presented itself a few days ago where before it worked just fine. If anyone else is experiencing this problem or might have a solution it would be much appreciated.