-
-
Fix sketch but not position
Dan must be in a newer version, but in 2006, this won't work. To do what Ken asked for (constrain all sketch entities in the logo to each other, but not to the sketch itself), I'd create a block with all the logo entities (Tools, Block, Make). The block will move as a unit (but can be change using Edit Block). -
Fix sketch but not position
Block or a Derived Sketch will also do what you ask.
The Fully Define Sketch used to be called Autodimension, and should work fine as long as you remove any dimensions to external entities.-
Fix sketch but not position
I kinda thought that AutoDimension would do the same as Fully Defined. I don't think it would work well in this instance, however. The original poster has a sketch containing a floor plan and a logo. He only wants the logo fixed with respect to itself. Fully defining would likely add dimensions fixing the logo to the floor plan thus adding a bunch of cleanup. Then again, I may be reading more between the lines than what's really there.-
Fix sketch but not position
I agree with you, Mark. I think in this instance probablymaking a sketch block is the way to go. I don't use them veryoften, so I never remember to suggest that route. However,without knowing the exact design intent one can never tell.
-
-