- SolidWorks 2015
- EPDM 2015
- Toolbox installed in EPDM Correctly
- I'm the Admin & have the toolbox checked out
Install has been working flawlessly for years. I was asked by my boss to add some special holes. I have done this many times with no issues. Ive copied the standard, changed the numbers in question, but when i go save it, it acts like it save it, even checks it in. when i access it in SolidWorks or even if i go back into the toolbox configurer, all my changes have reverted to the previous numbers.
Ive tried this on 2 different machines to no improvement.