I try to use thread command but I'm getting like this, can any one help me how to right way "THREAD COMMAND"?
You need to change the thread size to match the diameter, in this case M8 x 1,25. Then change the "Rotation angle" to 0 deg.
its showing error "Unable to cut thread on cylinder Surface. use extrude thread instead"
you must use extrude thread option only for bolt (Bar)
and cut extrude option only for holes.
I use cut for external threads.
how u use cut for thread???
I make my extrude the nominal diameter of the thread - say 1/2" then select the edge shown, select the face to end and locate the profile.
This is the result:
What is the thread size you are after?
If it's M10 as in your part, you need to change your Boss-Extrude4 feature to diameter 10, delete your current thread feature & add again. I couldn't get it to work just changing shaft diameter & using yuour current thread feature.
Hope this helps.
You just need to click the "mirror profile" button and that should yield the result you are looking for.
Retrieving data ...