In the pas i make a mistake and make some of configuration as children. is there any way to make them as parent config .
This currently isn't possible but you could try the work around suggested on the knowledge base
Hope this helps
This new configuration can not have the same name as the original derived one. But if you then delete the old derived configuration, and rename the new top-level configuration to EXACTLY the same name, assemblies and drawings SHOULD attach to the correct configuration. At least it worked this way some years ago.
Anyway - for this kind of operation - REMEMBER BACKUP !!!
Thank you very much for this,only yesterday I had the same problem.It`s good enough way.
Tanks very much .
Retrieving data ...