0 Replies Latest reply on Jan 17, 2016 12:01 AM by Kamal Mohamed

    Help on nonlinear simulation

    Kamal Mohamed

      Hi I am new to solid works and trying to get around the simulation.

      I am trying to find out the amount of load require to separate the 2 piece.

      Under simulation I chose non linear - dynamic 2d - plane 2mm.

      Fixeture

      Contacts.

      I am not sure what to add so i did as below.

      Deleted the component contact

      And i mesh and run

      and keep on getting this error.

       

      Please tell me if my steps is correct?