Why in an assembly, in an attempt to make a "Cut Extrude" thru the entire model, it fails to cut one particular part?
If the component is not a solid body, the extruded cut will not affect it. Is this a solid body or surfaces?
Check the status of the Feature Scope radio buttons and selection list. You might have that one item excluded from components to cut list.
It's hard to tell from the second image but the gear is not in the selection list so it is excluded from the cut.
my bad....I knew better than that. It is because it is a surface part, not a solid.
thank you all!
Retrieving data ...