I want to create a drill with a spiral body(like the image i upload) attached to the front bike and I'm wondering how to do this you could give me an idea?
Start with a cone
Draw a helix with a diameter larger than the largest part of the screw thread
sketch a line from the end of the helix to the axis of the cone
surface sweep that line along the helix, then thicken
Make a new conical surface to cut off the excess threads
split to finish
hei'ya Bma Bma,
my take on your screw point-
part file att.SW16
use the rollback bar to inspect the build
hope this helps- have a good'n kelef
Retrieving data ...