7 Replies Latest reply on Jan 14, 2016 5:27 PM by Muhammad Ayub

    Steel Panel zig zag Cut ?

    Muhammad Ayub

      Hi Everyone,

      very simple question,

      i have inclined Steel  Stick (thickness 6mm, height 2500mm 50mm large) then i create a new sketch on it, to apply the cut.

      now when i used linear pattern i want the cut make a zig zag, gos up then down. like in second image that i have done in another Software.

      Thank you so much.

       

      Panel.jpg

       

      Panel ok.jpg