hello, can someone help me with assembling? i need to assemble 1 cilinder to its base, and it needs to be 2mm deep inside.
You will need two mates, each one between the an edges and the face.
or you could create a reference plane in the "cylinder" part, and then mate this plane with a 2mm offset to the face.
As Leszek Paprota suggested I created a mate 2mm ( I used inches but you get the idea) less than the radius of the round part and assembled the top plane to the plate surface.
see if this is helps-
some forward planning makes
the assy. easier
hope this helps- have a good'n kelef
Retrieving data ...