'fan out' of wires in 2008

Discussion created by Rick Beddoe on Oct 12, 2007
Latest reply on Oct 12, 2007 by Steve Ostrovsky

Like • Show 0 Likes0
Comment • 1

In wiring summaries in 2007, it was possible to set the connectorsto show a 'fan out' of wires to the corresponding pins.

2008 now has the 'Flatten Route' capability which is awesome!

.However, it does not show the individual wire-to-pin geometry noris there a 'fan out' option. Does anyone know if this is possiblein '08 using 'Flatten Route'?

Outcomes

1 Reply

Steve Ostrovsky Oct 12, 2007 7:46 PM
I don't know about the wire-to-pin geometry, but the I believe the fan out is capable. When you flatten your harness, there's an option to move the individual wires around. It's basically sketch relations and all the wires start off with a vertical or horizontal relation. You can remove the relation and free-drag to create the fan out. Hopefully it's a good first start at flattening.
Like • Show 0 Likes0
Actions

'fan out' of wires in 2008

Outcomes

Related Content

Recommended Content