13 Replies Latest reply on Jun 3, 2008 9:09 AM by Karthik Sugumaran

    adding rib to curved edge

    Eli Novin
      Hello,

      I am trying to insert a rib between two surfaces that are boundedby curved edges. I can draw a line from edge to edge, but as soonas the rib feature fires up it cannot make the rib terminate on thecurved edge. in the preview, you can see that the yellow lines ofthe rib extend past the curve (see jpg screenshot). any ideas onhow to do this?

      I attached the file. you can see that I tried to work around it bydropping the line inside the object so that the rib doesnt extendpast the curve.

      thanks!