AnsweredAssumed Answered

Scaling down derived fastener holes

Question asked by Amruthkiran Hegde on Dec 14, 2015

Hello,

 

So here is the challenge. I have a model where the holes for the fasteners have been derived from a parent sketch I think (this is visible in Sample 1 that is attached). I would like to scale down the model, but, when I try doing that the holes do not scale down appropriately and interfere with each other (as seen in Sample 2 that is attached). I know that I can underive the holes and manually dimension them before scaling them down, but I am pretty sure that there must be a quicker way to do it.

 

Thank you.

 

Amruth

Attachments

Outcomes