1 Reply Latest reply on Dec 10, 2015 3:51 PM by Kenneth Barrentine

Auto populate dowel pin symbols on a specified layer.

Ryan Quinn Dec 10, 2015 2:53 PM

I am setting up our drawings to auto place dimensions, center lines, tables etc in specified layers. I do not see anywhere to set what layer dowel pins will populate in.

Re: Auto populate dowel pin symbols on a specified layer.

Kenneth Barrentine Dec 10, 2015 3:51 PM (in response to Ryan Quinn)

it was not included in the document properties;
additional annotations that were left out in the cold are hatch, datum target, end treatment and caterpillar.
Like Show 0 Likes(0)

Actions