2 Replies Latest reply on Dec 10, 2015 11:41 AM by Matthew Lorono

    2015 Setting to keep Bom order.

    robert dattilo

      Hello;

           I was wondering what the new setting is in SW 2015, that allows you to replace a component, where the replaced component retains it's position in the bom order. It's been frustrating, especially doing alot of repetitious drawings when SW, would put it at the bottom of the bom.

      In the real world it doesn't work that way. If you replace a component, on the drawing the old/new swap retains it's position whether it was 1, or 53 or whatever.

           We finally upgraded to 2015, & I remember them talking about this at the Demo I attended. Doe's anyone know off hand what the settings are for this?

       

      Thanks in advance,

      Rob_D SW 2015 Sp4.