- What version of SW are you running ?
- What drafting standard are you using ?
- Have you altered it ?
- If you hover over the view, how is the bounding box shown.
- Can you upload a simple part on a drawing ?
Select the section arrow, and drag it to where you want it to be.
I think there is nothing to control that, can´t find it.
Modeled a plate that was 100x100mm put it on a A3 sheet format with the scale 1:1. The section arrows where far away from the part as you can see from the image. If I put the plate view scale to 1:10 it got cluttered.
Other then manually drag it further away like you have been doing you could use the next sheet format above then you are using now so you don´t need to scale the views that much down. I use A3 sheet format 90% for my work and though I have small parts that could easily be put on A4 sheet format I just don´t do it, in fact I never use A4 sheet format.
Hope this helps.
section lines are not dynamic
it's not possible
I can drag it to where it should be, no problem.
But don't want every user to do that for every drawing.
Desire to set it up properly in the template to avoid dragging manually.