AnsweredAssumed Answered

Why are my results not available?

Question asked by Jim Steinmeyer on Dec 2, 2015
Latest reply on Dec 3, 2015 by Jim Steinmeyer

In the attached simulation I am attempting to determine the moment and deflection of the lower surface of a trailer side when loaded with grain. I have run the simulation a couple of times by selecting "mesh and run". The event completes in a little over an hour but then does not display any results and the icons for selecting stress, strain or any other output are all grayed out. I would suspect that there is an error but no error messages are shown. Can someone suggest where my error is?

We are running SW 2015 SP4.

 

Thank you

Jim

Attachments

Outcomes