AnsweredAssumed Answered

How do I do this?

Question asked by Karl Martin on Nov 30, 2015
Latest reply on Nov 30, 2015 by Prasad Bhonsule

Hi Everyone,


I know this probably seems so simple but I'm relatively new to Soildworks.

However, I can't figure out how to create an extrusion along a curve.


Basically I'm looking to

- Create a 30mm extrusion from Plane 3 upwards on the inside of the part along the curvature of the part.

- I've tried to do it by creating a new part then combining them but there's a few complications with this when it comes to filleting.


If anyone could help that would be great!