Hello everyone,
I'm currently a student who's learning Solidworks in college, however for one of our projects I can't figure out how to properly create my product.
I feel my ways of making it are too geometric while I'm looking for a more organic and curved shape.
I would greatly appreciate it if someone could perhaps show me how to do this. Its an animal feeder
The walls are 25mm with a 3mm cavity inside.
Regards,
Karl.
No its an outdoor animal feeder. I have looked at surfacing videos but still can't figure it out
Yes, Surface.
Create imagens for each view: Front, Side & Top.
Insert each in the same planes.
Create contour lines.
Or create sketchs like this video:
Thanks, do you think you could try this and ill use the roll back feature to see how you did it and ill try myself?
Thats if youve time of course.
Karl
I will create as the video and send asap.
Thank you so so much!!
Your e-mail please
I would strongly recommend removing your email from public view and send Jose a message instead.
Sent to you.
I tried to make as close as possible, even if your draft is too bad...
Hi Jose
I've yet to receive it.
Karl
Hi Karl, according to your sketch the overall dimension shown in the sketch is 450 and if you subtract the other dimension of 360. The difference is 90 which according to the sketch looks like it should be the upper radius, but there is a dimension showing the top being 385 diameter. (385 divided by 2 equals 192.5) something needs to be changed I think?
Is it a fuel tank? If so, it does not show a fuel inlet or a connection for a fuel line outlet. This looks like a surfacing project. I would check out the tutorials on surfacing.