AnsweredAssumed Answered

Assembly Fillet Doesn't Work as Expected

Question asked by John Willett on Nov 23, 2015
Latest reply on Nov 26, 2015 by Jose Araujo

I'm trying to place a concave fillet over the "re-entrant" edge between two parts in contact.  The edge is selected in the image below, with the "screw" part highlighted to distinguish it from "test block 1."  (I'm pretty sure I've done this successfully before, but not this time!)

Edge Selection in Assembly.png

This time, Assembly Features/Fillet creates a convex fillet on the selected edge of "test block 1," exactly as though it were a fillet in that part itself, rather than filling in the re-entrant edge as I intended.  Please tell me what I am doing wrong. -- John Willett

Outcomes