AnsweredAssumed Answered

Help with a radius groove on edge of model needed.

Question asked by Kevin Milligan on Nov 18, 2015
Latest reply on Nov 18, 2015 by Kevin Milligan

Hello,

 

New to SW and to this forum. I have created my first part and I am stuck at the last feature I need to create. I need a radius groove similar to the ones already on the two edges shown. I need it to wrap around the radius of the part. I was successful with the straight extruded cuts, but can't figure out if its a revolved cut or how I need to do it. When I try a revolved cut, I am unable to specify an axis to revolve about. Perhaps I just don't understand the axis needed to revolve around?? Any help would be greatly appreciated. I'm running SW 14.

 

Outcomes