I tried to create a 380 mm long,6 mm diameter long thread bar. Whet I give swept cut, it is loading 2/3 min then deselect the profile and path doing nothing. But swept cut is working good for 100 mm long helix path. Where is the problem.
Sahan,... be nice to yourself, your computer and the people who would work with this data,..
Seriously... please do not create a full 380mm long thread if you don't have too.
for instance... a single 380mm sweep takes > "7X" longer to regenerate over a "patterned thread" (38X @ 10mm).
also,.. do a simplified set of configurations.. such as,.. just show the start and end (general use)... or just show a simple thread (a minor circle for layout use)...
btw,.. your graphics card... personally this taxes any card... so make sure your image quality settings are not turned up high,.. turn them down to something which is tolerable for you.
For my part, I have problems with the cut extrude on free forms. It can take me 15 min if it doesn't crash. When I contacted SW, they told me that my graphic card is the problem. But, I find bizzar that when I try the same cut extrude on a cylinder which is as big as my piece, it works.
Still searching for an answer. I will also change my graphic card but don't think that the problem will solve with it.
Retrieving data ...