4 Replies Latest reply on Nov 9, 2015 1:14 AM by Antonio Cavka

Pack and go

Antonio Cavka Nov 7, 2015 3:54 AM

hi,

i had this already on forum,but i did not solve it,hope it will be this time

I hew one project and i want to do another project(most parts are same),but i want to hew version 1 and version 2 . I am using pack and go but for some reasons i can not include all drawings that are referenced to 3D parts. Some drawings are included !!!

why happens that ? and is there a another way to do it ?

i tried to copy and advanced options but results are same...

nice day all

Re: Pack and go

Adel Taheri Aval Nov 7, 2015 5:29 AM (in response to Antonio Cavka)

Hi Antonio
you can make configuration and in drawing select desired configure
Like Show 0 Likes(0)

Actions
- Re: Pack and go
  
  Antonio Cavka Nov 7, 2015 6:11 AM (in response to Adel Taheri Aval)
  
  hi Adel
  i do not understand what u mean by that, can u tell me more detail (i hew lot of parts it wild be many work to edit one by one)
  
  Like Show 0 Likes(0)
  
  Actions
Re: Pack and go

Jamil Snead Nov 8, 2015 10:17 PM (in response to Antonio Cavka)

Make sure all of the drawings that you want included are in the same folder as the assembly that you are pack and going.
Like Show 1 Likes(1)

Actions
- Re: Pack and go
  
  Antonio Cavka Nov 9, 2015 1:14 AM (in response to Jamil Snead)
  
  u saved me again,ty u
  i had 2 folders first for 3D components and second for they drawings,that is why it has not work
  nice day
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post