SW 14 Every time I create a new plane, my computer locks up for a minute. if I try to input numbers for plane offset, or plane angle, it locks for two minutes.
I uninstalled/ re-install SW and still have the same issue. Is this a common problem, a known bug, or is my computer whacked.
Anybody else had this problem? Is there a fix?
I had SolidCam installed on this computer and it caused SW to run slow and crash. SC support thinks I need a better graphics card, so I uninstalled SC, that did not help with the SW create a plane issue. Could there be some legacy files from SC that cause SW to crash.
Any input appreciated.