0 Replies Latest reply on Nov 3, 2015 1:15 PM by Yosef Yoely

    Simplifying assembly for analysis

    Yosef Yoely

      Hi,

      I have an assembly (~150 components) that I need to analyze.

      Most of the parts and sub-assemblies are frozen or not owned by me (we work with ePDM 2014).

       

      For preparation the analysis, I would like to simplify the parts (remove holes, chamfers, fillets ...).

       

      My problem is I cannot find a way to do this while maintaining the associativity of the assembly.

      I want to make simplification so, if I were required to make a change in the design; I do not have to do the process all over again.