This content has been marked as final.
Show 3 replies

2D geometry defined by a polynomial equation
Dan Riffell Sep 21, 2007 2:35 PM (in response to 111AQO9)Unfortunately, you cannot currently drive a spline with apolynomial equation. You can however drive the position ofthe points along the spline. There is a command: Insert > Curve >Curve thru XYZ points. You may also be able to use a macro todrive the points. I think I've seen one somewhere before. I'm sure somebody here will remember where.
Hope that helps. 
2D geometry defined by a polynomial equation
Charles Culp Sep 21, 2007 2:40 PM (in response to 111AQO9)Read the last two posts on this thread:
http://forum.solidworks.com/forum/messageview.cfm?catid=4&threadid=3247
and the first half of this one:
http://forum.solidworks.com/forum/messageview.cfm?catid=10&threadid=6224
and this one:
http://forum.solidworks.com/forum/messageview.cfm?catid=11&threadid=6253
and for some functionality, try Matt Lombard's macro page:
http://mysite.verizon.net/mjlombard/

2D geometry defined by a polynomial equation
Mahir Abrahim Sep 22, 2007 6:57 AM (in response to 111AQO9)There you go.