When I rotate a view (SW 2015) an arrow is shown in the label indicating Clockwise or Counter Clockwise. Is this a drawing standard i.e. ANSI
or is it just Solidworks?I like the idea of it, but if it is not a standard we can't use it on our drawings.
ASME 14.3-1994 paragraph 1.7.4 says you can do this, saying "The angle and direction of rotation shall be placed beneath the view title." The figure in the ASME standard shows it spelled out in text (see below), but they don't say it must be done that way. I think SolidWork's solution complies.
Correct, it is per standard in ASME 14.3-2003. SOLIDWORKS also supports the 1994 method that Dwight mentioned.
Thanks Guys. This is exactly the info I needed!!!
Retrieving data ...