AnsweredAssumed Answered

After upgrading from 2011 to 2013, I've noticed that when I use the measure tool there is a new drop-down list next to the on-screen measurement.  This is fine except for the fact that the drop-down covers up the first digit of the measurement!  How can I

Question asked by Jason Foulger on Oct 23, 2015
Latest reply on Oct 23, 2015 by Jason Foulger
  • Comment • 2

Capture.JPG

As shown here, you can only see the 515.80mm but the actual value is 2515.80mm.  The box is covering up the 2.  I'm sure it's an easy fix, but haven't been able to figure it out.  Please help.

 

Jason

Glenn Schroeder
Glenn Schroeder Oct 23, 2015 5:49 PM
Correct Answer

Welcome to the forum.  See if this will help:

 

https://forum.solidworks.com/message/474850#474850

See the reply in context
No one else had this question

Outcomes