2 Replies Latest reply on Oct 19, 2015 1:40 PM by Rob S.

Saving to PDF

Rob S. Oct 19, 2015 1:24 PM

When I save my assemblies to PDF, they have a very glossy and shiny appearance. I would like to have the PDF image look identical to how the assembly appears in Solidworks. Can somebody let me know if there is a setting or something I am missing here?

Thanks

Re: Saving to PDF

Jamil Snead Oct 19, 2015 1:29 PM (in response to Rob S.)

I don't know why they would save out differently than they appear in SW, I don't know of a setting to control that. But it sounds like it is saving the pdf with RealView on. Check to make sure RealView is not enabled.
Like Show 1 Likes(1)

Actions
- Re: Saving to PDF
  
  Rob S. Oct 19, 2015 1:40 PM (in response to Jamil Snead)
  
  Realview is off. This is how my PDF's look:
  
  The image on the top left is the assembly in solidworks, the bottom left is the PDF.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post