3 Replies Latest reply on Nov 11, 2015 10:36 AM by Chris Canterbury

EPDM crashes when changing states on an open file

Chris Canterbury Oct 19, 2015 11:02 AM

One of the problems I keep having is that I will open a drawing to see if I actually need to make any changes to it. If I do need to change it, I need to change its state in EPDM. Every single frickin' time I do that, it crashes windows explorer/EPDM.

SWX 2015 x64

Is this a new feature to prevent working too quickly? Is it possible to prevent EPDM from crashing when changing the state of a drawing/assembly/part that is open?

Hope somebody knows.

-Chris

Re: EPDM crashes when changing states on an open file

Chris Canterbury Oct 19, 2015 12:48 PM (in response to Chris Canterbury)

Okay, it crashes on EVERY initial state change regardless of whether it's open.

SWX 2015 is just SO much better than 2012.
Like Show 0 Likes(0)

Actions
- Re: EPDM crashes when changing states on an open file
  
  Jim Sculley Oct 19, 2015 1:31 PM (in response to Chris Canterbury)
  
  Do you have any custom EPDM add-ins installed? What transition actions (if any) are being performed as part of the state change? Are there multiple transitions from your initial state? If so, do all transitions lead to a crash or just a particular transition?
  
  Jim S.
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: EPDM crashes when changing states on an open file
    
    Chris Canterbury Nov 11, 2015 10:36 AM (in response to Jim Sculley)
    
    No custom add-ons of any sort, as far as I know. I don't think any other actions are being performed. I need to change the state of a part or assy from Design to Drafting Required (or any other state), but doing so crashes windows explorer every single time. I do this a lot, so it adds up to quite a bit of wasted time.
    
    Like Show 0 Likes(0)
    
    Actions

Go to original post