AnsweredAssumed Answered

Routing Twists

Question asked by Kevin Pymm on Oct 15, 2015
Latest reply on Apr 14, 2016 by Kevin Pymm

I am having issues when creating routes for cables & wires. As you can see from the image below I am getting a twist in the cable/wire, sometimes there are more than one in each section. Sometimes they are subtle, sometimes very pronounced. When rendered out the issue is produced in the render.

 

Routing.jpg

 

 

 

Routing Closeup.jpg

 

 

 

Not sure if anyone else has seen this issue or can figure out a solution. If you can it would be greatly appreciated, I have been trying for several versions of SW's to sort this issue without success.

 

I have attached the above sample assembly if anyone wants to have a play....SW 2016

 

Cheers.

Attachments

Outcomes