2 Replies Latest reply on Oct 5, 2015 12:36 PM by Trinny Tat

[New to SolidWorks] Different drawing than the Help-Tutorial 3: Drawings

Trinny Tat Oct 5, 2015 1:59 AM

I follow the instructions of the SolidWorks Help Tutorial but could not create the same drawings as shown in the tutorial

My drawing

The drawing that the tutorial shows

And

Not sure what I did wrong or if there are certain settings on mine that prevents the drawing of actually showing the fillets. Please help me figure this out

Re: [New to SolidWorks] Different drawing than the Help-Tutorial 3: Drawings

Wojciech Paterski Oct 5, 2015 2:59 AM (in response to Trinny Tat)

Right click inside view and select option: Tangent Edge -> and choose proper option. This is for setting individually for each drawing view.
If you want tangent edges always to show on new view then go to settings: System Options - > Drawings -> Display Style ( I think that's the one)
Like Show 0 Likes(0)

Actions
- Re: [New to SolidWorks] Different drawing than the Help-Tutorial 3: Drawings
  
  Trinny Tat Oct 5, 2015 12:36 PM (in response to Wojciech Paterski)
  
  Thank you, that was very helpful!
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post