0 Replies Latest reply on Sep 29, 2015 12:27 AM by Pouria Alavi

    Inventor iassembly

    Pouria Alavi

      Does any one know if SolidWorks has a similar logic capability in an assembly like iassembly in Inventor.  I need to suppress a component in assembly base on change in geometry of another part in the same assembly.

        e.g if diameter of  part1=10mm, then unsuppress 10mm shaft and suppress a 5mm shaft.

      I know you can derive a parameter of a part from assembly design table.  Can you control a suppression of a component in an assembly from a part design table?

      Thanks