when i want to move a small component (like a small bolt) in an assembly , should zoom out from it but when the component become small in graphic area it become impossible to move it by lmb (left click bottom) . why this happen?
You can zoom into your small part, right click on it & select "Move with Triad", then you can zoom out & drag/rotate your part to its new location. If the option is not available you may need to add it by going to bottom of your list & select "Customize".
You can also pre-select your component, zoom out & use the "Move Component" command on the Assembly tab.
no way is there?
you solve a big problem for me . good luck
Retrieving data ...