AnsweredAssumed Answered

Is there a way to show a single bend line?

Question asked by brandon michaelis on Sep 18, 2015
Latest reply on Sep 19, 2015 by John Mullett

So we create a lot of bent sheet metal parts, including rectangle to rectangle transitions.  When creating these parts using Sheet Metal, it appears that SW does not give the option to bend the part using a single bend line in the corners.  As a result, the flat pattern on the drawing shows (2) bend lines at the tangents.  This is driving our shop bonkers.  Is there a setting I can change to show a single bend line at the middle of the bend?

Outcomes